Fillets, Reinforcements, Terminations & Details
Bituthene® Liquid Membrane
A two component, elastomeric, cold-applied, trowel grade material designed for a variety of uses with the Bituthene Waterproofing System. Ideally suited for use as a fillet material at inside corners; reinforcement at inside corners, flashing material around drains, protrusions, curbs and parapets; sealing material at terminations; repair material for defects on concrete surfaces; and as a flashing material at corners.
A rubberized asphalt-based mastic. It has excellent adhesion to structural concrete, masonry and wood and is designed to seal terminations, edges of patches, and overlaps in detail areas. It is an integral part of the Bituthene Waterproofing System, though it should not be used as a primary waterproofing material.
A specially formulated two sided, reinforced pressure-sensitive tape. The bottom side has a highly aggressive, pressure-sensitive adhesive designed to adhere to penetrations, protrusions and Bituthene membranes. The topside has another layer of adhesive and a coating that protects the tape from the weather and UV light for up to 30 days following application. Used in detail areas including end laps, penetrations and various tie-ins.
Bituthene® Edgeguard Tape
A specially formulated tape designed for applications where resistance to hydrocarbon contaminated soil is required. It is made of a 0.05 mm (0.002 in.) polyester film with a pressure-sensitive solvent resistant acrylic adhesive. It is recommended for use over the membrane edges to protect the adhesive from prolonged exposure to hydrocarbon contaminated soil.