Grace Construction Products

Grace Logo
Product Selection

Self-Adhesive Sheet Waterproofing

Bituthene® System 4000 Membrane
A composite membrane with a thickness of 1.5mm (0.060 in). It consists of 1.4mm (0.056 in.) of rubberized asphalt and 0.1 mm (0.004 in.) of cross laminated, high density polyethylene film. They combine to provide a tough waterproofing barrier. The unique rubberized asphalt eliminates the need for traditional solvent-based primers. Ideal for application in interior or hard to ventilate areas or where flammability is an added concern. Use with Bituthene System® 4000 Surface Conditioner.

Click here to see Ancillary Products Chart
Data Sheet Detail Drawing Tech Letters Application Procedure Specifications

Bituthene® 3000 Membrane
A composite membrane with a thickness of 1.5mm (0.060 in). It consists of 1.4mm (0.056 in.) of rubberized asphalt and 0.1 mm (0.004 in.) of cross laminated, high density polyethylene film. They combine to provide a tough waterproofing barrier. Bituthene 3000 is self-adhesive and cold applied. Ideal for waterproofing concrete, masonry and wood surfaces where in-service temperatures will not exceed 54° C (130° F). Use with Bituthene Primers.

Project Using This Product: Singapore Mass Rapid Transit System
Click here to see Ancillary Products Chart
Data Sheet Detail Drawing Tech Letters Application Procedure Specifications

Bituthene® Low Temperature Membrane
A composite membrane with a thickness of 1.5mm (0.060 in). It consists of 1.4mm (0.056 in.) of rubberized asphalt and 0.1 mm (0.004 in.) of cross laminated, high density polyethylene film. They combine to provide a tough waterproofing barrier. May be applied when surface and ambient temperatures are between -4° C (25° F) and 16° C (60° F). Use with Bituthene Primers.
Data Sheet Detail Drawing Tech Letters Application Procedure

Bituthene® 5000 Membrane
A factory made composite product with a thickness of 1.7 mm (0.065 in). It is composed of 1.4 mm (0.056 in.) of rubberized asphalt and a layer of heat resistant woven polypropylene mesh. Self-adhesive and cold applied, the product is ideal for waterproofing concrete surfaces on which hot asphaltic concrete overlays are installed, such as on parking decks and bridges where in-service temperatures will not exceed 54° C (130° F).

Click here to see Ancillary Products Chart
Data Sheet Detail Drawing Tech Letters Application Procedure Specifications

Perm-A-Barrier® Wall Membrane
A tough, self-adhering, self-healing composite membrane. It consists of 0.9 mm (.036 in) of rubberized asphalt and an integrally bonded 0.1mm (.004 in), high density cross laminated polyethylene film. When combined with a structural substrate, Perm-A-Barrier wall membrane produces a virtually impermeable air and water barrier on concrete, masonry, gypsum board and wood walls. It is designed to be a cost-effective system which acts as both an air and vapor barrier. Perm-A-Barrier Wall Membrane retards the diffusion of moisture through the building enclosure. It provides a continuous seal against air and vapor leakage around the entire building.
Data Sheet Specifications

HydroPly® Dampproofing Membrane
no longer available


Specifications | Contact Us | Links | Product Guide | Project Profiles | FAQs

Grace Constructon Products Home Page | W.R. Grace & Co. Home Page

Copyright ©2000 W.R. Grace & Co. -- Conn.